Cadillac 2011 SRX User Manual Page 406

  • Download
  • Add to my manuals
  • Print
  • Page
    / 502
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 405
Black plate (68,1)
Cadillac SRX Owner Manual - 2011
10-68 Vehicle Care
A Tire and Loading Information
label shows the size of the original
equipment tires and the correct
inflation pressure for the tires when
they are cold. See Vehicle Load
Limits on page 912, for an example
of the Tire and Loading Information
label and its location. Also see Tire
Pressure on page 1063.
The TPMS can warn about a
low tire pressure condition but
it does not replace normal tire
maintenance. See Tire Inspection
on page 1071, Tire Rotation on
page 1071 and Tires on
page 1056.
Notice: Tire sealant
materials are not all the same.
A non-approved tire sealant
could damage the TPMS sensors.
TPMS sensor damage caused by
using an incorrect tire sealant
is not covered by the vehicle
warranty. Always use only
the GM-approved tire sealant
available through your dealer
or included in the vehicle.
Factory-installed Tire Inflator Kits
use a GM approved liquid tire
sealant. Using non-approved tire
sealants could damage the TPMS
sensors. See Tire Sealant and
Compressor Kit on page 1081 for
information regarding the inflator
kit materials and instructions.
TPMS Malfunction Light and
Message
The TPMS will not function properly
if one or more of the TPMS sensors
are missing or inoperable. When
the system detects a malfunction,
the low tire pressure warning light
flashes for about one minute and
then stays on for the remainder of
the ignition cycle. A DIC warning
message also displays. The
malfunction light and DIC warning
message come on at each ignition
cycle until the problem is corrected.
Some of the conditions that can
cause these to come on are:
.
One of the road tires has been
replaced with the spare tire.
The spare tire does not have a
TPMS sensor. The malfunction
light and the DIC message
should go off after the road
tire is replaced and the sensor
matching process is performed
successfully. See "TPMS Sensor
Matching Process" later in this
section.
Page view 405
1 2 ... 401 402 403 404 405 406 407 408 409 410 411 ... 501 502

Comments to this Manuals

No comments