Cadillac 2010 Escalade User Manual download pdf (Page 518)

100

101

Black plate (70,1)

Cadillac Escalade/Escalade ESV Owner Manual - 2010

TPMS Sensor Matching Process

Each TPMS sensor has a unique identification code.

Any time you rotate your vehicle's tires or replace one

or more of the TPMS sensors, the identification codes

will need to be matched to the new tire/wheel position.

The sensors are matched to the tire/wheel positions in

the following order: driver side front tire, passenger side

front tire, passenger side rear tire, and driver side rear

tire using a TPMS diagnostic tool. See your dealer for

service.

The TPMS sensors can also be matched to each tire/

wheel position by increasing or decreasing the tire's air

pressure. If increasing the tire's air pressure, do not

exceed the maximum inflation pressure indicated on the

tire's sidewall.

To decrease air-pressure out of a tire you can use the

pointed end of the valve cap, a pencil-style air pressure

gauge, or a key.

You have two minutes to match the first tire/wheel

position, and five minutes overall to match all four tire/

wheel positions. If it takes longer than two minutes, to

match the first tire and wheel, or more than five minutes

to match all four tire and wheel positions the matching

process stops and you need to start over.

The TPMS sensor matching process is outlined below:

1. Set the parking brake.

2. Turn the ignition switch to ON/RUN with the

engine off.

3. Press

Q and K on the Remote Keyless

Entry (RKE) transmitter at the same time for

approximately five seconds. The horn sounds

twice to signal the receiver is in relearn mode and

TIRE LEARNING ACTIVE message displays on

the DIC screen.

4. Start with the driver side front tire.

7-70

1 2 ... 513 514 515 516 517 518 519 520 521 522 523 ... 619 620

Comments to this Manuals

No comments

Cadillac 2010 Escalade User Manual Page 518

Comments to this Manuals

Related products and manuals for Cars Cadillac 2010 Escalade