Cadillac 2008 escalade esv Operations Instructions download pdf (Page 15)

13

Refer to Owner Manual for further information.

J Reviewed with Customer (Please Check Box)

Driver

Information

Safety &

Security

Comfort Performance &

Maintenance

Owner

Privileges

TM

Entertainment Convenience

After a remote start, the engine will

run for about 10 minutes before

turning itself off, but can be

extended 10 minutes by performing

another remote start sequence at any

time. After two consecutive remote

starts, no additional remote starts are

allowed until the vehicle has been

started with the ignition key.

The vehicle’s climate control system

will automatically heat or cool the

vehicle interior to 74°F (23°C), and

adjust the airflow to the defrost

or vent mode depending on

ambient conditions.

Starting the Vehicle

To remote start the vehicle:

1. Aim the RKE transmitter at

the vehicle.

2. Press and release the (Lock)

button on the transmitter.

3. Immediately press and hold the

(Remote Vehicle Start) button

for about four seconds.

4. When the parking lamps flash,

release the button. The engine will

start and the parking lamps will

remain on. The engine will

continue to run for 10 minutes.

5. Repeat these steps for a 10-minute

time extension.

When you enter the vehicle after a

remote start, the key must be

inserted in the ignition and turned

to the Run position before driving.

Canceling a Remote Start

If you wish to turn off the engine

instead of driving after a remote

start, perform one of the

following functions:

• Press and hold the button until

the parking lamps turn off.

• Press and release the Hazard

Warning Flashers button inside the

vehicle. Press the button again to

turn off the flashers.

• Turn the key in the ignition switch

on and then off.

• The engine will automatically stop

when time expires.

AUTO TURN SIGNAL

The turn signal lever includes an

automatic lane change signal feature.

To signal a lane change, raise or

lower the lever until the arrow on the

instrument panel cluster starts to

flash, and then release the lever. The

turn signal will automatically flash

three times. If the Tow/Haul mode

is selected, the turn signal will

automatically flash six times.

To signal a turn, move the lever all

the way up or down.

INTELLIBEAM™ AUTOMATIC

HEADLAMPS (if equipped)

IntelliBeam uses a digital light sensor

behind the inside rearview mirror to

maximize forward night vision. The

system automatically switches on the

high-beam headlamps when no other

vehicle traffic is present, and switches

to low beam intensity when the

headlamps or taillamps of other

vehicles are detected. The system

operates only when driving over

20 mph (32 km/h).

The system is turned on

automatically when the headlamp

system is set to AUTO and the turn

Note: The Remote Vehicle Start feature

will not operate if the key is in the

ignition, a door or the hood is open, or

if the Check Engine light is illuminated

on the instrument panel cluster.

76885_08a_Escalade_ESV_052407.qxd:Escalade_ESV 2007 A 5/24/07 2:32 PM Page 15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Comments to this Manuals

No comments