Cadillac 2000 Catera Owner's Manual download pdf (Page 122)

2-57

Programming the Sunroof

If the battery on your vehicle has been recharged,

disconnected or is not working, you will need to

reprogram the sunroof following these steps. Refer to the

illustration under “Sunroof” for control dial positions.

With your vehicle’s ignition on:

1. If the sunroof is closed, turn the control dial to

position E. Hold the dial in position for about

five seconds.

If the sunroof is open, turn the control dial to E and

hold until the glass panel has closed. Now continue

holding the dial for approximately five more seconds.

2. Turn the control dial to position G and hold until the

sunroof is fully tilted (about three seconds after the

motor has stopped).

3. Now turn the control dial to position E and

keep holding until the sunroof is fully closed

(about three seconds after the motor has stopped).

4. Turn the control dial to position A and hold until the

sunroof is fully open (about three seconds after the

motor has stopped).

5. Turn to position E and keep holding the

control dial until the sunroof has fully closed

(about three seconds after the motor has stopped).

The sunroof is now programmed.

Please note that if the sunroof keeps opening after you

attempt to close it once it has been programmed, you

will need to repeat Steps 2 through 5 (up to three times

if needed). If you are still having problems, consult your

dealer for service.

Also keep in mind that if something is in the way of the

sunroof closing during programming and you continue

to program the sunroof, the sunroof will only open or

close to the spot where the obstruction occurred. You

will need to reprogram the sunroof again, making sure

that the object has been removed.

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 320 321

No comments

Cadillac 2000 Catera Owner's Manual Page 122