Cadillac 2015 Escalade Technical Information download pdf (Page 68)

Black plate (67,1)

Cadillac Escalade CUE Infotainment System (GMNA-Localizing-U.S./Canada-

8140416) - 2015 - crc - 1/15/14

Infotainment System 67

To reset the system back to the

factory default settings:

1. Press the SETUP button on the

remote control.

2. Use the left/right and down

navigation arrows on the remote

control to select the Default

sub-menu under the Preference

Page and press the ENTER

button to reset the settings. The

parental settings will not be

affected.

Vehicle Speakers

Audio from the DVD player or an

auxiliary device can be heard

through the vehicle speakers or the

wireless/wired headphones, while

the radio is tuned to one of the six

frequencies selected on the Sound

Around portion of the system’s

remote control. See “Remote

Control” later in this section.

Only one audio source can be heard

through the vehicle’s speakers at a

time. The audio source being used

is specified by the A/V (audio/video)

source selected on the driver side

head restraint video display screen.

To turn the RSE system audio

output to the vehicle’s speakers,

press Sound Around ON, on the

system’s remote control. The audio

from the RSE system can be heard

through the wireless/wired

headphones and the vehicle’s

speakers at the same time. The

volume on the radio can vary when

switching between the radio, CD,

DVD, MP3, or an auxiliary device.

Wireless Headphones

The two wireless headphones

included with the Headrest DVD

RSE system will only work with the

Headrest DVD RSE system and are

marked for channel 3 and 4. The

wireless headphones must be used

within a line of sight of the

transmitter that is located above the

video display screen.

3-4 Channel Selector: This is

located on the right earpiece. Either

Channel 3 or 4 can be selected with

the channel selector. The driver side

monitor is designated as Channel 3,

and the passenger side as Channel

4. Set the channel selector switch

according to the video display

screen being viewed. The message,

“To listen to this monitor tune your

headphones to Channel 3 (or 4)”

displays for five seconds then

disappears when the video display

screen is turned on.

OFF/ON (Power): Turn the power

switch located on the earpiece to

turn the wireless headphones on or

off. Each headphone has a light to

indicate ON. If the light does not

come on, the batteries may need to

be replaced. See “Battery

Replacement” under Rear Seat

Entertainment (RSE) System on

page 35 or Rear Seat Entertainment

(RSE) System (Platinum) on

page 54 for more information.

The headphones shut off

automatically if the RSE system is

turned off or if the headphones are

out of range of the transmitter for

more than three minutes.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 136 137

Comments to this Manuals

No comments